[PinSound 1] After the beeping stops I try to start a game and there is no sound

Question

I am trying to put the original sounds into my Data East pinball machine with my pinsound board but it doesn't seem to be working. I have checked and made sure the folders are in the right order, but to no result. the only sound i here is the ordinary boot up sound. After the beeping stops I try to start a game and there is no sound. before I put the board in the game was working perfectly. Please help me solve this problem.

Answer 1

Could you check that:

- the ribbon cable is plugged into the Data-East connector (and not the System11 slot)

- the ribbon cable is correctly connected: the red side must be turned to "1 red" (printed on the PinSound board). Also, make sure that this ribbon cable is correctly connected onto the main MPU board (red side to the pin 1).

- you've turned up your knob volume to the right (near the coin box)